- 净化系统内通风量应在净化器额定处理风量内；1the amount of ventilation in the purification system should be within the rated air flow rate of the purifier;
- 净化器安装应保证水平，否则，净化器收集的油会被风机吸出，或放油时不能将净化器内的油放尽； installation should ensure that the level, otherwise, the oil purifier collected by wind suction, or put the oil can not be put in the oil purifier;
- 管道内风速应设计在8-10m/s; wind speed pipe should be designed in 8-10m/s
- 弯头中线半径≥1.5D（若不满足此条件，则变径管风阻会成倍增大） elbow radius is larger than 1.5D midline (if not meet this condition, it will increase the drag reducing pipe)
- 变径管（小变大）斜边与轴线夹角≤70（若不满足此条件，应考虑合理安装导流板。否则，净化器净化效率将大幅度降低而不能达到国家排放标准） tube (small and large) bevel angles with the axis is less than or equal to 70 (if you do not meet this condition, should consider the reasonable installation guide plate. Otherwise, the purification efficiency of the purifier will be greatly reduced and can not meet the national emission standards.
- 变径管（大变小）你斜边与轴线夹角≤150（若不满足此条件，应考虑合理安装导流板。否则，净化器不能发挥器效能）。如图所示；7 tube (big or small) your bevel angles with the axis is less than or equal to 150 (if you do not meet this condition, should consider the reasonable installation guide plate. Otherwise, the purifier can not play the effectiveness of the device. As shown in figure;
- 净化器进风口之前应有一段≥2.5D的直管（若不满足此条件，应考虑合理安装气流均布板和导流板。否则，净化器不能发挥器效能 ）；Before the 8 air purifier should be a straight over 2.5D (if this condition is not met, should consider the reasonable layout and installation flow guide plate. Otherwise, the purifier can not play the effectiveness of the device;
- 风机应安装减振器；fan should be installed vibration damper;
- 风机进出风口应安装软连接； wind turbine inlet and outlet should be installed soft connection;
- 净化器必须可靠接地（净化器有3根出线，红线和绿线接220V/AC，黄绿线接地）purifier must be reliable grounding (purifier has 3 stages, red and green 220V/AC, green line)
- 风向问题：设备出厂均设定为左进风（面对净化器电气箱的门），风向流动邮左进风，反之则为右进风）。若现场需用右进风，电场旋转180°，将弹簧接头由下方移至上方，再将高压线对换则完成了由左进风调整为右进风之过程。wind problem: equipment factory was set up at the left Jinfeng (face purifier electric box door), wind flow post left Jinfeng, whereas right into the wind). If the site use right into the wind, the electric field will rotate 180 degrees, from below to above the spring joint, then on the high voltage line is completed by adjusting inlet for Jinfeng left right.
- 为保证设备的净化效率，设备工作在负风压状态，即风机必须设在设备后面。 in order to ensure the efficiency of the equipment, the equipment works in a negative pressure state, that is, the wind turbine must be located in the back of the equipment.
- 室外安装时，应加装防雨、遮阳的遮阳蓬，以免影响设备的正常使用寿命以及增加不必要的维护费用。 outdoor installation, should be equipped with sunshade rainproof and sunshade, so as not to affect the normal service life of equipment and increase unnecessary maintenance costs.
广杰—防紫外线油脂过滤器
GOJEK—UVgrease filter
专利净化器品牌
90%以上油烟异味处理效率
符合新国标及广东、上海、北京等地方新标准
100%实现低空排放
设备特点
1、SUS304不锈钢边框，铝合金过滤型材高效除油烟净化率>90%，优于国标
2、无需任何辅助材料（如水、电、药剂等）
3、机械原理，大大减少了产品使用和维护成本
4、用户可自行安装及清洗，节省费用，方便快捷
5、防透光设计，可有效避免因紫外线外泄导致的人体伤害
6、通过火焰蔓延保护测试，能有效预防火苗串入烟罩风管，从而消除火灾隐患
7、通过ISO品质认证，CE安规认证，国家环境保护产品认证等各项证书
8、UV专用型防紫外线油脂过滤器是GOJEK为了配合GOJEK烟罩专用型光解净化器而研发的新型油脂过滤器，该产品应用在UV—C厨房吸气罩时，可以有效阻挡UV—C强紫外线透光，防止强紫外线光线外泄导致的人身事故。
设备原理
油脂、水蒸汽和固体颗粒物通过三级调整旋风和有瓦伦型材的摩擦力，被有效过滤。旋风，凹凸体结构及专用涂层可确保紫外线光100%不会外溢
1、厨房油脂 在气态环境中对液滴和固体微粒进行分离
2、油雾 在温度/压力降低时从饱和的蒸汽中析出的液体微粒
3、蒸汽 蒸汽压力<1.013mbar的普通环境温度下产生的物质
4、精细微粒 直径中<10um的固体颗粒物
应用领域
小吃、路边摊类 工业、食品加工业 除臭系统 自助餐、便当类 饭店百货业类 烧烤、碳烤类
学校、医院类 连锁速食、员工餐厅
产品优势
1、最新专利技术，90%（10）um净化效率
2、安装在烟罩内，有效防止风管积油
3、可搭配低空排放系统
4、可选配紫外线除味系统
5、防火型设计，减少火灾隐患
6、无需水电，零耗材，节能环保
7、用户可自行安装及清洗，节省费用，方便快捷
"};
